Nissan 350Z Dodge Mopar 8HP Aluminum Driveshaft | ASE
Pickup currently not available
A direct bolt-in aluminum driveshaft for completing a Dodge Mopar 8HP transmission conversion in the Nissan 350Z. This version is built for the car-platform 8HP used in the Dodge Charger and Challenger, with its 6-bolt output flange. Like the rest of our aluminum shafts, it is rated to hold roughly 1,100 whp.
- 3" diameter 6061 aluminum tube with 1/8" wall
- Spicer 1350 solid-body universal joints
- Sonnax slip yoke with high-angle provision on a 1-7/8" spline coupler
- Lower weight and rotating mass than a steel shaft, for quicker acceleration
- Easy bolt-in installation
Quiet running that still holds power
Every shaft uses a Sonnax slip yoke with high-angle provision on the 1-7/8" spline coupler. That combination is how we deliver a driveshaft that runs smooth and silent on the street while still handling the power of a built 8HP car.
What else you need
Only one adapter is required: a front adapter for the 8HP output flange, listed separately as the Driveshaft Adapter Dodge Mopar 8HP50 8HP70 1310 1350. The rear of the shaft bolts to the factory differential with no adapter.
Which 8HP this fits
This version is for the Dodge Mopar car-platform 8HP with the 6-bolt output flange.
Running a Jaguar 8HP45 or 8HP70? The Jaguar 8HP45 and 8HP70 also use a 6-bolt output flange, but on a different bolt circle diameter, so this shaft and its front adapter will not fit them. Order the Nissan 350Z Jaguar 8HP Aluminum Driveshaft instead.
If you are running a BMW or truck-platform 8HP, contact us before ordering.