2JZ 1JZ to BMW ZF 8HP50 8HP70 8HP75 Conversion Kit | ASE
Pickup currently not available
This is a complete conversion kit for your JZ engine. Kit comprised of Billet Convertor Adapter plate, Billet Flex Plate to replace weak steel OEM JZ flex plate and a billet engine to transmission adapter plate.
- Billet 6061 Components
- Billet TQ Convertor Adapter Plate
- Billet Flex Plate
- Billet Motor Adapter Plate
- Complete Hardware Kit
- Pilot Spud adapter
- Hardened Steel Ring Gear
- Precision Dowel Pins for Proper Alignment
Which 8HP transmissions this kit covers
This kit covers the BMW 8HP50, 8HP51, 8HP70, 8HP75 and 8HP76 cases listed below. ASE builds kits across the larger 8HP range — 8HP50 through 8HP96 — in BMW, Mopar, Dodge/Ram truck, EcoDiesel and Jaguar variants.
The small BMW / Dodge 8HP45 is not supported. (The Jaguar 8HP45 is a separate case — it shares Jaguar's unique four-bolt torque converter with the Jaguar 8HP70 and is covered by the Jaguar kit.)
Why the BMW small case is a two-piece assembly
On the small case BMW transmissions the smaller torque converter overlaps the area where the starter ring gear needs to sit. A bolt cannot run through the ring gear teeth, and removing enough material to clear it would leave a part prone to cracking. This kit is therefore built as a two-piece assembly, located by a precision machined alignment spud that drops into the center.
You will also need a TCU
This kit is the mechanical engine-to-transmission adapter only. The 8HP is electronically controlled and will not shift without a standalone transmission controller — such as the TurboLamik TCU 8HP Controller — purchased separately.
Watch the full 8HP range overview
Read the complete 8HP swap kit guide →
Transmission Fitment List: