This collection gathers FuelTech's fuel delivery parts: steel-mesh filters with a built-in pressure sensor port, injector connector kits for custom harnesses, FT Injectors and peak & hold drivers, and the blower EFI injector manifold.
Filters — the FT Filter uses a 60-micron steel mesh element, an O-ring gasket and a 1/8 NPT port for a pressure sensor. The fuel version comes in 12AN; the fuel & oil version in 12AN and 16AN. Replacement elements are sold separately.
Injector connectors — pick the kit that matches your injector plug: EV1, EV6/EV14 or Nippon Denso. The EV1 kit includes a 90-degree boot.
Injectors and drivers — high impedance injectors run from the ECU; low impedance injectors need a peak & hold driver.
Monitor fuel pressure at the filter. The FT Filter's 1/8 NPT port takes a FuelTech pressure sensor directly, so you can log fuel pressure without adding a separate tee.
FuelTechFuelTech Fuel InjectorsFuelTech Fuel SystemsFuelTech High Impedance Injectors
Replacement O-rings for FuelTech FT Injectors in upper and lower sizes. Use them when servicing injectors or reinstalling them in a rail. Upper: 7.52...
A connector kit for injectors that use the Nippon Denso style plug, for building or repairing a custom injector harness. Nippon Denso injector connector...
A connector kit for terminating injectors with EV6/EV14 connectors on a custom harness. It is specified for use with Injector Dynamics injectors. EV6/EV14 injector...
Everything needed to terminate one EV1-style injector on a custom harness: the connector, two terminals and a 90-degree boot to protect the wiring. EV1...
FuelTechFuelTech Fuel FiltersFuelTech Fuel Systems
The factory replacement 60-micron steel mesh element for the FuelTech FT Fuel Filter. It drops into your existing housing to restore full filtration without...
We use cookies to improve your experience on our website. Read about how we use cookies in our Privacy Policy. By browsing this website, you agree to our use of cookies.
privacy policy