The connector kit for wiring a FuelTech Peak & Hold injector driver into your harness and FuelTech engine management system. Mates with the FuelTech...
FuelTech complete harnesses are wired for external Peak & Hold drivers. When you run high impedance injectors instead, this jumper plugs into the driver...
This harness wires FuelTech's Peak & Hold PRO injector driver into the engine management system. The driver is what lets an ECU control high-performance...
FuelTechFuelTech Fuel InjectorsFuelTech Peak & Hold Drivers
The FuelTech PRO HV-8 is a high-voltage injector driver that handles both gasoline direct injection (GDI) and high-flow port (PFI) injectors, low or high...
The harness-side version of the 10-way connector kit for FuelTech PRO550 and PRO600 wiring. FuelTech does not publish further detail for this part; confirm...
The harness-side version of the 12-way connector kit for FuelTech PRO550 and PRO600 wiring. FuelTech does not publish further detail for this part; confirm...
The harness-side version of the 16-way connector kit for FuelTech PRO550 and PRO600 wiring. FuelTech does not publish further detail for this part; confirm...
The harness-side version of the 8-way connector kit for FuelTech PRO550 and PRO600 wiring. FuelTech does not publish further detail for this part; confirm...
A single input/output terminal for the PRO550 and PRO600 expansion connectors, for adding or repairing a circuit. For PRO550/600 8, 10, 12 and 16-way...
A single harness-side input/output terminal for the PRO550 and PRO600 8, 10, 12 and 16-way connectors. Harness-side terminal For PRO550/600 8, 10, 12 and...
This lightweight billet block mounts up to four pressure sensors in one place, away from high-vibration areas. Each sensor has its own top-to-bottom port,...
We use cookies to improve your experience on our website. Read about how we use cookies in our Privacy Policy. By browsing this website, you agree to our use of cookies.
privacy policy